Interface that sends and receives non-encapsulated (non-tagged) frames.Īn access port can be assigned to only one VLAN.
To access unconditionally and operates as a non-trunking, single VLAN This mode, the switch supports simultaneous tagged and untagged traicĬonigures the VLAN membership mode of a port. Sets the trunk characteristics when the interface is in trunking mode. Ip nat inside source Ī coniguration mode command that deines the matching criteria to mapĨ02 frames ingress on an interface to the appropriate service instance
Sets a static route in the IP routing table In passive RIP mode, RIP routing updates are accepted by, but not sent out In router coniguration mode, sets only that interface to passive RIP mode. In router coniguration mode, associates a network with a RIP routing In router coniguration mode, disables automatic summarization Logs you into enable mode, which is also known as user exec mode orĪn enable mode command to display the running coniguration for aĭisplays the usability status of interfaces that are conigured for IPĪ conigure mode command that sets the IP addresses of DNSĮnables a Routing Information Protocol (RIP) routing process, which places Sets a host name to the current Cisco network device While “no shutdown” brings up the interface Sets the default gateway on a Cisco deviceĪn enable mode command that displays the current conigurationĪ conig interface command to describe or name an interfaceĮnters interface coniguration mode for the speciied fast ethernet interfaceĪn enable mode command that copies iles from one ile location to anotherĪn enable mode command that saves the active conig, replacing the startupĬonig when a Cisco network device initializesĪn enable mode command that merges the startup conig with theĪn enable mode command that deletes the startup conig An exec mode command that reboots a Cisco switch or router